I m now thinking that I should setup a different router (I have several spares) to see if the same (negative) action occurs. I tried “pinging” in DOS window, getting a response but after the addresses’ IP, I seem get the DNS IP address which tells me I’m pinging it rather than the indicated IP address of the camera (result: pinging 192.168.1.126:81 (20869.32.145) with 32 bytes of data:….). I also used the setup wizard to gain access with same result. It is here the problem occurs: putting the detected IP address into the browser gets me nowhere (times out attempting to connect) so I can’t gain access! I cannot gain access to it to log-in and make the necessary changes to the IP so I can see the camera over the Internet. The setup software detects and identifies the IP address, etc, of the cam OK. Any suggestions would be appreciated.įirst, yes, both computer and camera are on the same network (both plugged into same router). I even tried to get the supplied cam setup software “wizard” to gain access but it indicates inability to access with words:”The IP Camera cannot be accessed” and “Please check the Internet”! I tried to play with the router port forwarding table putting in the identified camera IP address along with port 81 and several other things but still can not gain access to the camera using the “identified” IP addresses so I can do the next steps to configure the camera so i can “see” it on the (external) Internet. Tried this operation with two networked computers with same outcome. Navigate to the Applications folder in the Finder, then double-click on the Photo Booth application icon. EASYN IP CAMERA SOFTWARE MAC MACThe software identified the unit with IP address, HTTP Port, Access IP (same as identified IP address) and I tried to access the cam using the IP address the software identified (192.168.1.216:81) but my browser cannot access it to go through the next step in the setup. Source: IPCamera Apps IPCamera Mac Apps for Foscam,VStarcam,Eye4,EasyN,P2P IPCamera. Used the included setup software to identify the cam after following the setup procedure by connecting it to the router via a LAN cable. Trying to access it through a DLink DIR-615 router. Have a wireless IP Wireless Camera (EasyN FS-613B).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |